It has been a while since I did this, but my recollection of the steps are
1. Install Growl on Mac
2. Install Prowl on iPhone
Follow these instructions:
https://www.prowlapp.com/installation.php
Click on the Applications tab/HaikuHelper in Growl preferences to make sure it is setup how you...
The scenario was that my fire alarm went off when I wasnt home. Received a notification on my phone. I checked my cameras in the house and everything looked ok. Cleared the alarm with Haiku via entering code. Alarm company called and I told them to cancel fire dept response.
Just still...
This may be more of an Omni question than a Haiku question, but If I clear a fire alarm remotely via Haiku and there is still smoke causing the fire alarm will the fire alarm activate again or is there a timeout that prevents it from re-activating for a certain timeframe.
Unfortunately, that didn't help...and now my Growl notification setup isn't working. I had installed Growl on my Mac and Pushover on my iPhone which was working in place of the Haiku notifications. It was working this morning and now it isn't. I can get notifications via email.
EDIT...
My notifications seemed to have stop working again. I made the changes as suggested in the thread at the end of February and was able to receive notifications over the last several weeks.
Anyone else having trouble again?
I have an OmniLTe panel. The LTe has 32 units available for allocation and I have already allocated 22 using HLC for "House Code Format" I have a Zigbee lock that works great with the panel.
I just purchased a Zigbee plug-in load module. It appears that to have the panel control it, I have...
Well, AT&T came out today. I explained the situation and asked them if we could try a new router. Tech said sure. Problem solved.
The new gateway is a Pace 5268AC. It allows entry of a static IP to create a port forward regardless if the device is detected by the gateway.
Thank you for...
I just tried this, but it didn't seem to work (that is, if I followed your directions correctly). I believe the issue is that the UVerse router configuration allows you to assign the port forwarding to a specific device, by MAC address, not by IP address.
When I changed my laptop to the...
I have an OmniLTe (4.0b) connected to an ATT UVerse NVR589 router. This setup has been working without a problem for almost two years. This week we had some issues with our ATT service and I was instructed by ATT to reboot my router by. I can't remember if I have ever done this before. ...
I am not at my Mac right now, but I think all I did was download Growl for the Mac ($3.99) and then created a Pushover account (Pushover.net) and downloaded it to my iPhone. I installed the Growl plug-in from the Pushover.net website. There is a code that you are given that you need to enter...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.