Hi all! I purchased a home that had an Omni LTe system already installed along with an Omnistat thermostat, along with a number of HLC switches. I replaced the thermostat with an Ecobee and I've been trying to remove the references to the previous thermostat from the system. I've loaded PCA, connected to the controller, and removed the references to the thermostat in the Thermostat section. I wrote to the controller and when I read back I can see it shows as Not Used. I don't see the thermostat when I look at the status tab while I'm connected anymore. However I still see the thermostat in Snaplink and it still shows up in OmniLinkBridge. I've of course reloaded the config in Snaplink, and I've restarted OmniLinkBridge, but for the life of me I can't seem to figure out how to get the system to stop reporting a thermostat as configured. I've read both the Installation as well as Owners manuals for the LTe and I am pretty sure I'm doing this correctly, and I've figured out I think almost everything else about the system, but this one has got me stumped.
Thanks!
Andrew
Thanks!
Andrew