I recently went through my Elk system with a fine tooth comb to verify termination etc. I've got a problem that I've isolated to one branch but can't figure out where the problem is
I have an M1G with an M1DBHR board to allow me additional runs
I have 8 keypads, 3 expanders etc. but I'll limit this to where the problem seems to be.
On the M1DBHR JP1 is terminated properly.
Branch 1 has 2 homeruns on it.
JP2 is not terminated
Homerun 1 goes to an M1KP that is terminated. This is keypad 1
Homerun 2 goes to my garage where the run daisy chains through an M1XIN (not terminated) and ends at an M1KPAS that is terminated
This branch is not terminated on the M1DBHR (JP2)
The keypad on Homerun 1 is terminated and has ID 1
The keypad on Homerun 2 is terminated and has ID 4
If I disconnect Homerun 2 and enroll then everything is fine. Keypad 1 is identified and everything else (other than what is on Homerun 2) is perfect.
If I then reconnect Homerun 2 and enroll then even though I've made sure to avoid a conflict by making the M1KPAS have ID 4 I lose keypad 1 - it shows as 'missing or not working'.
This is driving me mental.
Any help would be appreciated.
mark
I have an M1G with an M1DBHR board to allow me additional runs
I have 8 keypads, 3 expanders etc. but I'll limit this to where the problem seems to be.
On the M1DBHR JP1 is terminated properly.
Branch 1 has 2 homeruns on it.
JP2 is not terminated
Homerun 1 goes to an M1KP that is terminated. This is keypad 1
Homerun 2 goes to my garage where the run daisy chains through an M1XIN (not terminated) and ends at an M1KPAS that is terminated
This branch is not terminated on the M1DBHR (JP2)
The keypad on Homerun 1 is terminated and has ID 1
The keypad on Homerun 2 is terminated and has ID 4
If I disconnect Homerun 2 and enroll then everything is fine. Keypad 1 is identified and everything else (other than what is on Homerun 2) is perfect.
If I then reconnect Homerun 2 and enroll then even though I've made sure to avoid a conflict by making the M1KPAS have ID 4 I lose keypad 1 - it shows as 'missing or not working'.
This is driving me mental.
Any help would be appreciated.
mark