Search results

See if this helps

When I built my sons house 17 years ago I set them up with the ElkM1 Gold. Also all Z-Wave lighting and door locks (3500 sqft - now 500 sqft with the basement finished). Along with that I used CQC for automation. The Elk does have the VRCOP for the interface via serial. In all the automations...

I have an extra 6160 (non RF) I could let go for a reasonable price if you decide to go that way. I just replaced my old Networx unit with a 20P.

Thank you for your time in finding those links. I am going to work on it today. I don't think buying an LCD keypad with what I have, not knowing if it will make a difference, is beneficial. If I can't figure it out with what I have I will probably just opt to replace with a Vista 20 or something...

Nothing I did would make it connect. A problem is that the keyboard I have is just led lights - no screen - so is really difficult to program. I finally reset it to factory default but now need to see if I can find time to reprogram it. I cant decide if it would be worth spending the money to...

Thanks for the links. I work on it today. What is frustrating is I have had it connected to my CQC system for years, and yet using the same serial configurations, it will not connect via DL900.

I know this is a long shot but thought I would try. 40 years ago I Installed an NX8E. It still has the original keypad. For years now I have really only used it for motion detection for my home automation. I am now redoing that also so thought it would be a good time to see if I can resurrect...

Where is yours getting the configuration sections of "Use listen Word" and Use Wake Word"?

Im using a reserved address in my router. It pings and shows up fine. It work by holding in the button and giving a command, it just does not respond to vocal

It doesnt show the last three lines Use Listen Light Use Listen Word

I've tried Alexa, hey jarvis, and ok nabu

Yeah, not happening here. Everything is enabled. If I hold down the button I can issue commands and they work. However nothing responds from the wake word. I push the button and the solid blue light comes on. Here is the log: s6-rc: info: service s6rc-oneshot-runner: starting s6-rc: info...

Let me correct that some. If I use the button then it will control devices via voice. However the awake will not work.

So not using https:// can you control devices (ei. lights) via voice control? When I try that it shows that i have to be logged in via secure to enable microphone control.

So I have it connected to HA. Forgot that I didn't need to connect to the device AP when using ESPHome. Now trying to get assist to work. Then in watching a youtube video Smart Home Junkie said that you have to use https:// in order to use local control. Is that what you have found? Do you use...

Pete, When you connected the Atom for the first time and connected to its AP, what address did you use to connect to it. For most ESP32 it is 192.168.4.1 but that isnt working with this.

Mine is supposed to arrive today. Will look forward to your post on the setup.

Received and email this morning that they were back in stock. Went to the link and they are already sold out again.

Hey Pete, Been away for awhile doing family stuff. I decided to try out the W880 again. Remember before how it said configurations had to be via yaml. Well now look at the message I get: I started from scratch and followed your instructions including changing the manifest like was noted. One...