Search results

I figured it out,apparently if you check mark where it says enable chime , it repeats the speak words, maybe it’s because I don’t have a lcd key pad with a chime.

Elk-M1 keeps repeating , e.g, it says front door is open twice, need some help in figuring out where to check for duplicate. Thanks

How do I add the Winland wbtx-345 wireless water sensor to a Elk-M1xrf2h??,thanks in advance.

Thanks RAL, I should have mentioned that I can arm and disarm from the keypad without any problems, but it only happens when trying to enrolment from the keypad, it’s weird.

Thanks RAL, I did all of that, I had a new keypad that wasn’t hooked up and I tried that with the right termination and did disconnect everything else and only had the keypad connected, only when I have exhausted everything that I tried then I would reach out to this forum for help, I just...

Need some help with this error on my keypad, I have checked and double checked wiring and it’s ok, it’s been working for over 8 years now and all of a sudden it’s giving error.see attached picture

Thanks RAL, I missed that.

The XRF2H V2 has no where for a Jumper.

Thanks RaL

I have the ELK-M1DBH connected to the data bus on the M1 gold board and a elk-M1KPNAV connected to the M1DBH via a RJ 45 jack, is it okay to connect the M1XRF2H V3 to the M1DBH or it’s better connected directly to the data bus on the m1 board?, thanks in advance for all the help.

Okay, thanks, I figured it out.

Yes I did

Hi , can anyone with knowledge on ELK-M1KPNAV please help/advise on what to do , I flashed the keypad with the new firmware and at the end it shows complete, then I clicked done and this is what it shows now. See attached screenshot, it shows address 1, model M1KP, hardware 0.0, boot ver: 0.0.0...

So I have my CT-800 setup and working on my Washer, the ct dry contact is connected to zone 16 of my elk m1, I dont have any other expansion boards and I am using these Rules: WHENEVER Washer Status (Zn 16)BECOMES NOT SECURE THEN TURN Output 100 ON FOR 5 MIN, RESTART TIMER IF RUNNING WHENEVER...

Thanks, but I want to use the ct-800 because I have an Elk M1 or Automation.

Hi Squiddy, I know this is an old post, but can you please post the images for the washer, tho

yes, i did,when i test the rule it would give a prompt that its not saved to the panel

yes Mike,i did all of that,i even clear all my lighting in elkrp2 lighting,then i did a new importof the UPB file, and that imported to 1 (A1) i then imported the insteon light file and that over ride the 1(A1) so i then copy that light file and paste it to 1(c1), then i imported back the upb...

Hi Mike, i tried that but got the same results,what else can do you think i am doing wrony? Thanks

Thanks Mike, will try that tonight.