Search results

For those that saw my issue regarding my AUX powered ELK-WSV noticed my solution was to connect the OPII Ground to Altronix Ground.  This lead me to another question to make sure I have my earth grounds and DC grounds all correct.   Here is my equipment: OmniProII (OPII) Expansion Enclosure #1...

I'm performing a console self test as described below after troubleshooting a "NO CONTROLLER DATA" error and I believe to ahve isolated the issue to this specific console.  At the point where I am supposed to test the display by pressing the keypad buttons, I get a screen full of question marks...

On the Omnipro II does the two-way voice module power count towards the 1 AMP budget from SWITCH 12V, AUXILIARY 12V, CONSOLE, AND OUTPUTS 1-8?   I noticed the following statement, "SWITCH 12V, AUXILIARY 12V, CONSOLE, AND OUTPUTS 1-8 ARE INCLUDED IN THE TOTAL DEVICE LOAD, WHICH CANNOT EXCEED 1...

I've had a Simply Automated UPB setup connected to my HIA Omnipro II for several years.  All devices worked 99% of time.  Every now and then a few lights wouldn't get commands, no big deal though.   I have 400A service with 2 main panels.  I have a HAI phase coupler installed.   Recently all...

I have attached my power spreadsheet.  Please critique   The summary is as follows: Source               Total mA OPII                    931 OPII-Sounder     525 ExpEncl1            326 ExpEncl2            328 Aux                     8475   I don't have all the sources loaded to the max as I'm...

I have 5 Costar 12-25SIR gas sensors. Apparently they haven't been working integrated with the Omnipro, just individually. I can't get them to work properly with Omnipro. This is what I have: Gas Sensors are wired daisy chained in a Normally Open configuration. They are connected to...

From the AquaConnect documentation for a AQ-CO-SERIAL, i believe my Pro-Link command to perofrm a button Press and Release of the "Lights" button is as follows: Message 1 sent out HAI Serial Port - ^P^B^H^I^@^\^P^C Message 2 Sent out Serial Port - ^P^B^B^|^@^]^P^C   (FYI - those are actually 4...

I have an airscape whole house fan.  I have attached a link to the installation manual.  Page 9 and 10 show schematics for the low voltage (24v) controls.  I can skip the wall switch when wiring directly from the Omnipro to the Airscape control board.  The wires at the airscape control board...

Has anybody been successful at utilizing their OmniproII (or other automation system) to monitor the status of their dog invisible fence and report the status?   Thanks for feedback.