Recent content by lakemirror

photos of blank haiku pages

  Will do.  Thanks.

Well, it looks like the problem probably wasn't with Haiku after all.  My OP2 has been acting squirrely lately, network problems, so I disconnected everything on my network with the exception of the pc with pcaccess.  I reloaded my last .pca backup, turned on wifi and fired up Haiku on my phone...

  No joy.  Tried it twice, clearing cache each time.  Exactly the same result.  Then tried a third time, bypassing my dyndns address and linking to the static local ip of the controller.  Same.  Tried intentionally putting the wrong ip address in, letting it try to connect and fail, then...

  Sounds innocuous enough.  I'll give it a try. 

  Thanks for the response....no specific area is set, and I've done the cache clear about a dozen times now.  Like I mentioned earlier, usually in a situation where an app just completely goes south I have deleted it and re-downloaded from itunes.  Unless you are able to tell me differently, and...

Yes I have, several times.

Quick additional info.  I can still do "all on" and "all off" for my lighting ("control" on haiku) and my hifi2 speakers, so I know haiku is still communicating with the panel.  Otherwise everything is just blank pages.

Could use some help.  I'm not a techie but know enough to be dangerous.   I have used the Haiku app with my OP2 panel for a long time now.  I don't use Haiku Helper, not a Mac in the house.  I'm on ios 10.2.1.  I can connect to my panel either via my wifi net or via the Internet.  OP2 firmware...

Update   Inspected the board for shorts, loose connections, etc.  Found the ethernet port badly bent.  Pulled the network cable the powered the system back up.  Seems to be running now.   Pressed the ethernet port back in as best I could and reconnected the network.  Got good signal, system...

Hi all.  Got issues with my panel that I'm going to try to troubleshoot myself but I have little faith in my abilities.  Might need to get a tech in the central Florida area who's familiar with the OP2 to help, might need to replace the panel.   Had a strange sequence of events over a couple of...

I will experiment and report back.   And it's good not to have to worry about WAF, but sorry to have had it happen that way.  In any case, I'm free until the next Miss Wrong comes along again.

Thanks, Pete.  My OP2 is set to not use eols.  Guess that simplifies that issue.   First thing I gotta do is get the expansion panel connected to the main panel.  It was installed when we built the house 12 years ago and I intended to use it for irrigation control, but I never hooked it up...

I also am looking into triggering a zone into unsecure mode in order to initiate an alarm state programmatically to be able to create a panic alarm.   I have an expansion cabinet in my garage with a 16 zone/16 output board, and an 8 relay module.   Just so I'm sure that I'm reading the manual...

  Thanks for asking.  Sometimes a graphical representation of items in a user interface is great, but it stinks in this application.  I have way too many zones and units to have to swipe through icons to find.     Icons can be pretty, and add a "gee whiz" factor to an app, but in this case it...